The use of the automatic labeling machine will inevitably lead to some problems. Today, the problems frequently presented by the automatic labeling machine are stopped, and I hope to bring you assistance:
1. Adjustment of the installation of the brushing device.
The center of the brush is aligned and the two sides are symmetrical. The brush is perpendicular to the exterior of the container. The stacking gap of the brushing sweeping container is: a single pressing brush is 10 mm to 15 mm, and the combined pressing brush is 5 mm to 10 mm. The position of the cleaning brush spacer sponge is 1 mm to 2 mm. Conditioning of the bottle head. The bottle head should be 20mm lower than the bottle when there is no bottle.
2. Adjustment of the label box.
Centerline of the standard box, the central axis of the standard station is tangent to the label paper, and the central axis of the target board is lined up at three points. The adjustment target board is tangent to the label paper (0 interval), and then the standard box is moved closer to 1 mm to 2 mm. The gap between the standard paper and the two sides of the bead should be between 0.8mm-1mm. The gap is too large to form the standard paper in the standard box, showing the oblique mark. If the gap is too small, the push mark will be poor. The adjustment of the position of the labeling hook of the standard box: the upper and lower, left and right grasping hooks are on the same vertical plane and the average effort is on the standard paper, so the label can be smoothly captured. Conditioning of the label supply roller: When there is no label, the label platen can be pressed to the front end of the label box and when the label is mounted, the label near the label hook can not be crushed.
3. Adjustment of the bottle star wheel, the bottle star wheel, and the bottle screw.
When the adjustment of the inlet and outlet star wheels and the feeding screw is stopped, the pressure head of the automatic labeling machine shall prevail. First adjust the bottle into the star wheel. When the bottle head just overwhelm the bottle, adjust the bottle into the star wheel so that the bottle is in the middle of the star wheel groove. Adjustment of the inlet screw: According to the inlet star wheel, when the bottle is in the middle of the groove of the inlet star wheel, adjust the auger so that the auger is pressed against the bottle side without displacement. Adjustment of the bottle star wheel: When the bottle head has just been lifted, adjust the star wheel so that the bottle is in the middle of the groove of the star wheel.
4. Adjustment of the standard station.
Adjustment of the squeegee and the rubber roller: the squeegee and the rubber roller can not show a gap over the entire length. If there is a gap, the eccentric bolt can be adjusted to adjust the squeegee. Conditioning of the rubber roller and the target plate: the target plate and the rubber roller only contact each other without any pressure. If the gap is too large, there will be too much glue on the label to form a silicone. The gap is too small, the contact is too tight, the glue will be squeezed away, and there is no glue on the half of the target. The theory proves that the gap between the target plate and the rubber roller is preferably between 0.1 mm and 0.2 mm. It can be done by adjusting the bearing housing at the lower part of the rubber roller, and if necessary, adjusting the bearing on the upper part of the rubber roller.